Dana 60, Dana 70, High Angle, Forged Driveshaft Yoke, 29 Spline, 1350, U-Bolt, (PM3112-5005) aka: 3-4-5731 esr3694275 and you won't have to

and you won't have to install them

C-C (square):        66mm x 66mm x 11mm hole Taco pattern

This unique pitman arm does NOT have the master/key way splines which allows you to adjust steering wheel center as needed (no need to file the flats because it doesn't have any)

Drag link hole:  OE and GM tie rod (ES2233L

Dana 60, Dana 70, High Angle, Forged Driveshaft Yoke, 29 Spline, 1350, U-Bolt, (PM3112-5005) aka: 3-4-5731 esr3694275 and you won't have toFORGED U bolt yoke, 1350, 29 spline This is a must have for the Dana 60. The OE cast version fails, and doesn't get as much angle. Our design raises the u joint from the mounting surface by 1 4" compared to an OE yoke; and allows for significantly increased drive line angle. We use precision machining and high strength forging techniques to make this yoke fit perfectly, and hold up to abuse. It uses U bolts to fasten the u joints instead of straps.