Pay in 4 interest-free payments of $33.83 Learn more
Ships within 48 hours · Estimated delivery Jul 29 - Aug 3
Use to connect CAN devices into Link CAN bus
Length adjustment only on inner side to provide more strength
9 sensor eliminates the signal loss
One sachet is enough for 2 headlamps
Link ECU Ballast Resistor (BAL6) Mitsubishi Use to connect CAN devicesFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 6 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 4. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the