Pay in 4 interest-free payments of $7.00 Learn more
Ships within 48 hours · Estimated delivery Jul 27 - Aug 1
Sides of the chisel tip are sharp to sever fibers on the pin side wall and makes it easier to get into the corner
Outer Case Dimensions: Approximately 27 inches (686mm) long X 7 inches (178 mm) wide
Tempered in a salt bath to HRC58-63
but they also guard against scratching
Rob Cosman's Marking Gauge Cutters without Rods Rate Set at 1.4048 Sides of the chisel tipWe offer replacement marking gauge cutters without rods for all of our marking gauges. While you will probably never wear out a marking gauge cutter, it is common to chip or break a cutter through use or by dropping your marking gauge. Our marking gauge cutters are designed to work with either a Cosmanized or a Rob Cosman marking gauge rod but they may fit any marking gauge rod that attaches the cutter with a 6 32 inch or 4mm threaded screww, but we
US$ 1611.84
US$ 2492.80
US$ 7204.80
US$ 25384.00